Forrest MM12102 Miter Master 12-Inch 100 Tooth 5/8-Inch Arbor .105-Inch Kerf Aluminum Cutting Circular Saw Blade

April 29th, 2013

Forrest MM12106 Miter Master 12-Inch 100 Tooth 5/8-Inch Arbor .105-Inch Kerf Wood Cutting Circular Saw Blade

April 23rd, 2013

Forrest's blades offer a superior cut that leaves a rip-cut saw edge that is as smooth as if it had been sanded, and a cross-cut edge that is almost mark-free. The blades run very quietly, and backside tearout in plywood is negligible. Each blade is virtually hand-made. The plate is hand-tensioned (up to 15 minutes per blade), superior C-4 carbide teeth are hand-brazed to the plate, and the blade is straightened and restraightened multiple times throughout the process. Think of a Forrest blade as a tool in your shop, not an accessory. Forrest stands behind it's blades by offering a sharpening service that bring blades back to the exact tolerances offered in a new blade. And this same exacting service is available for other manufacturer's blades as well, so they should come back better than new. Forrest Woodworker 2 Saw Blade For Table Saws. With this one all purpose blade you can RIP & CROSSCUT 1' to 2' hardwood and softwood resulting in a smooth as sanded surface. Ply-veneers of oak and birch will crosscut with NO BOTTOM SPLINTER at moderate feed rates. Customized Forrest Woodworker 2 For Table Saws. For the advanced table saw operator. Ideal for joinery and special uses. Specially engineered clearances on the carbide teeth can totally eliminate side scoring. The result…no planing/jointing or sanding. In many cases a glue-line cut can be obtained, depending on the accuracy of the saw machine.20�� Face Hook for easy feedDOUBLE HARD and 40% STRONGER C-4 CARBIDE will give up to 300% longer life between sharpenings.Ends second-step finishing (jointing and sanding not required).Buy and sharpen ONE blade instead of 3, (24T Rip, 50T Combination, 80T Crosscut).Ends cutting 1/16' oversize to allow for RESURFACING

Forrest H4756 8″ x 5/8″ 24t Dado Blade Set

March 31st, 2013

The world's finest dado head cleancuts all your grooves! No splintering when cross-cutting oak, ply veneers and melamine. Perfect for flat-bottomed grooves. No staggered steps or round bottoms like a wobble-dado leaves! Cuts in all directions – rip, cross-cut, miter, any depth. Cuts all sized grooves 1/4" through 29/32" increments. Super-hard carbide gives up to 300% longer life, especially good on plywoods and abrasive particle-boards.

Forrest CM151006100 Chopmaster 15-Inch 100 Tooth ATB Miter Saw Blade with 1-Inch Arbor

March 4th, 2013

RSS Feed