Woodhaven 4965 Super Sled

April 21st, 2013

The Super Sled does it all! The sliding platform measures 23-3/4" square x 3/4" thick. It provides a zero-clearance edge for easy part alignment and clean cuts. Designed to be used on a table saw with at least a 27" deep table. 2-3/8" thickness capacity on most 10" saws. Platform supports parts for crosscuts up 19-1/4" wide (fully supported on platform) or 17-1/4" wide with platform toggle clamps attached. 28" taper length capacity.
Includes a 23-3/4" adjustable steel miter bar that eliminates any side play. Bar rides in your saws 3/8" x 3/4" miter slot. Slot must be between 4" to 7-1/2" from the blade, measured from the blade side of the slot. Can be used in the left or right miter slot. Bar attaches to the platform for either crosscut or taper operation and switches in minutes.
32" Ultra Track fence mounts horizontally for tapers or vertically for crosscuts. Fence can be pivoted clockwise or counterclockwise on the platform for unlimited crosscut and taper settings. All fence adjustments made with knobs.
Indexing holes in platform and stainless steel indexing pins set the fence at the most common angles of 0, 15, 22.5, 30, 36 & 45ยบ. Like our Deluxe Miter gauge, this pin setting method takes the guess work out setting angles and insures the best accuracy. Angles are engraved in the platform for easy reference. Other angles can be set using our optional Mite-R-Gage, or a digital protractor you supply.
Includes a 4519 3" Straight Flip Stop for use with crosscut work on the vertical fence.
Includes an edge stop for use with taper work on the horizontal fence.
Includes two 500 lb. toggle clamps and hardware. Clamps hold stock up to 1-3/4" thick and mount on the horizontal fence for holding tapers, or to the platform for holding crosscuts.
Optional 6305R 1" Riser Kit increases toggle clamp capacity to 2-3/4" thick stock, one required for each clamp.
Optional 789S Flip Stop is used with the fence in the horizontal position.

RSS Feed